Import PAD location from .def for allegro APD+

Kuz9l

Hello, I have a project that was made in innovus. I uploaded the .def file.
In cadence allegro I would like to create a die according to the size of the PADs that are in the def file.
If I follow the route specified in the manual, create an idf file, then load def, then I get 2 pictures, but I need the PADs to look like the first one

If I ask a question in the wrong section, please write where I could ask it?
Thanks in advance for your answer

tencome

Pad size is wrong?   You can give me .mcm file for check.

Or follow below sequence to modify single pad size.
1. General edit- Find "symbols" -  Select symbol by your mouse --  Property Edit - delete "locked"
2.  Symbol edit - Find "pins"-  Select pin by your mouse  --  Replace padstack

Kuz9l

tencome 发表于 2024-3-29 11:48
Pad size is wrong?   You can give me .mcm file for check.

Or follow below sequence to modify singl ...

[прикрепить]904641[/прикрепить]

Kuz9l

I want the Pads to be different colors and signed

tencome

Kuz9l 发表于 2024-3-30 00:40
I want the Pads to be different colors and signed

you can import DIE_data.txt  file to MCM file.  

1.  use different pad stack name.

2.  color can assign by  "assign color" command.

Kuz9l

tencome 发表于 2024-3-30 17:14
you can import DIE_data.txt  file to MCM file.  

1.  use different pad stack name.

Thanks a lot