Plexim Plecs Standalone v3.2.7 win32/64 + Crack

rp2004

after some time of running it says "license problem detected" and closes up. something is wrong with the medicine

rp2004

has someone encountered the same "license problem detected" after say 5 minutes of running? I think there was a 30 day time limit embodied in the software that wasn't cured by the pill. If you move the PC's date say 2 months ahead you'll get the same message.

KHL

之前安裝好能跑我就丟上來了
所以沒有測試調整日期後的狀況
有找到新的破解我會再丟上來

rp2004

the previous versions were running OK, but 3.2.7 is giving me these license problems. If I set the date of the PC a couple of days back plecs seems to run OK (at least for 15 minutes). If I set it a couple of months back it gives me "broken pipe" error message. If I set the date a couple of years ahead, install it and then set the date back to normal it continues to produce "license problem" error message. Pain..., unfortunately the older versions (that used to run problem free) are now behaving in the same manner. Tested on a couple of PCs - the same problem. The BEAN guys didn't do a good job this time

xiaofeng2001

感谢哥哥～·

xiaofeng2001

哥哥，我也遇到5分钟就报错的问题，请尽快解决啊

rp2004

回复 17# xiaofeng2001

xiaofeng2001, you said you had the same error message but resolved the problem. What did you do to resolve it?
(I do not exclude that the Google chrome translator I used might have been incorrect and you were actually saying that you had the same problem and asked somebody to resolve it)

qqflybirds

非常谢谢。

rp2004

Guys, do you have the same license error or not? It looks that to trigger the error one has to run the prog for a couple of hours first. The license error appears in a day or two after that when running the prog for a couple of minutes. Have you observed this issue too?

hahtb

找了好久……感谢楼主的分享~~