|
发表于 2015-1-15 01:41:15
|
显示全部楼层
本帖最后由 YULONGUTK 于 2015-1-15 01:42 编辑
回复 1# jackyezhang
老大,为啥我老是出现这个错误?可能和units.dat有关,但这个文件很少动的。多谢多谢!!我是在RHEL7下。
Allegro PCB Design XL (legacy) 16.6 P4 Linux I64
(c) Copyright 1986-2012 Cadence Design Systems, Inc.
All Rights Reserved.
unit specifier 'MHO' not found in UNITS environment
unit specifier 'W' not found in UNITS environment
'w/cm-degC' and 'W/M-DEGC' are not equivalent units
unit specifier 'MHO' not found in UNITS environment
unit specifier 'W' not found in UNITS environment
'w/cm-degC' and 'W/M-DEGC' are not equivalent units
unit specifier 'MHO' not found in UNITS environment
unit specifier 'W' not found in UNITS environment
'w/cm-degC' and 'W/M-DEGC' are not equivalent units
unit specifier 'MHO' not found in UNITS environment
unit specifier 'W' not found in UNITS environment
'w/cm-degC' and 'W/M-DEGC' are not equivalent units
unit specifier 'MHO' not found in UNITS environment
unit specifier 'W' not found in UNITS environment
'w/cm-degC' and 'W/M-DEGC' are not equivalent units
warning: no preferred units for 'ETCH_THICKNESS'
unit specifier 'MIL' not found in UNITS environment
warning: no preferred units for 'ETCH_THICKNESS'
unit specifier 'MIL' not found in UNITS environment
warning: no preferred units for 'ETCH_THICKNESS'
unit specifier 'MIL' not found in UNITS environment
warning: no preferred units for 'ETCH_THICKNESS'
unit specifier 'MIL' not found in UNITS environment
warning: no preferred units for 'ETCH_THICKNESS'
unit specifier 'MIL' not found in UNITS environment
Termination codes: exit=3, signal=11, errno=2 |
|