[新手求助]编译成功但无bit文件是怎么回事？

danilliu

大家好！

我在用SPARTAN6尝试做一个驱动视频显示的Demo。用XPS设计了Microblaze、video-out、video-time-control等IP，然后编译，显示Done，但是在输出到SDK命令时没有任何反应（SDK没有启动），经查，XPS中没有生成bitstream文件，不知道是什么问题，应该从哪里查起？

如有任何帮助，不胜感谢！

输出到SDK命令执行时的显示如下：

WARNING:EDK:878 - Could not find IP doc
   http://www.xilinx.com/cgi-bin/docs/ipdoc?c=axi_gpio;v=v1_01_b;d=ds744_axi_gpi
   o.pdf
WARNING:EDK:878 - Could not find IP doc
   http://www.xilinx.com/cgi-bin/docs/ipdoc?c=clock_generator;v=v4_03_a;d=clock_
   generator.pdf
Generated Block Diagram.
Rasterizing v_tpg_0.jpg.....
Rasterizing v_tc_0.jpg.....
Rasterizing v_axi4s_vid_out_0.jpg.....
Rasterizing proc_sys_reset_0.jpg.....
Rasterizing microblaze_0_ilmb.jpg.....
Rasterizing microblaze_0_i_bram_ctrl.jpg.....
Rasterizing microblaze_0_dlmb.jpg.....
Rasterizing microblaze_0_d_bram_ctrl.jpg.....
Rasterizing microblaze_0_bram_block.jpg.....
Rasterizing microblaze_0.jpg.....
Rasterizing lcd_control_0.jpg.....
Rasterizing debug_module.jpg.....
Rasterizing clock_generator_0.jpg.....
Rasterizing axi4lite_0.jpg.....
Rasterizing axi4_0.jpg.....
Rasterizing MCB_DDR2.jpg.....
Rasterizing LED4bits.jpg.....
Rasterizing clock_generator_1.jpg.....
Rasterizing system_blkd.jpg.....
Report generated.
Report generation completed.