PEX提取寄生参数后后仿显示net error

五九X改

之前后仿都没问题，改了testbench的一个输入信号源后，后仿突然显示net error。前仿没有问题，重新提取寄生参数依旧不行。

具体报错如下：

Begin Incremental Netlisting May 13 17:50:32 2023
ERROR (OSSHNL-153): Failed to initialize incremental netlisting because the run directory contains
netlist data from the previous netlisting session which has a corrupt global
map structure file '/home/Huang_L/simulation/31_CISCOC/Bias_Stackv2_tb/adexl/results/data/Interactive.5/1/31_CISCOC:Bias_Stackv2_tb:1/netlist/ihnl/globalmap'. Remove the "ihnl" and "map" directories from the
current run directory and netlist again.

"ERROR (OSSHNL-512): Failed to generate netlist because incremental netlisting data from the previous session is corrupt or missing. Clean the run directory and netlist the entire design.\n"
End netlisting May 13 17:50:32 2023
ERROR (OSSHNL-514): Netlist generation failed because of the errors reported above. The netlist might not have been generated at all, or the generated netlist could be corrupt. Fix the reported errors and regenerate the netlist.
      ...unsuccessful.

SXF_

楼主找到原因了吗，我也出现了这种情况

SXF_

重启了一下，换了一下simulation地址可以了

@@@12

SXF_ 发表于 2023-6-20 16:07
重启了一下，换了一下simulation地址可以了

thank you. 666

@@@12

SXF_ 发表于 2023-6-20 16:07
重启了一下，换了一下simulation地址可以了

perfect

吕意昂

SXF_ 发表于 2023-6-20 16:07
重启了一下，换了一下simulation地址可以了

请问怎么换simulation地址啊？小白一个，一直没解决这个问题

cuihaofeng

@@@12 发表于 2023-11-1 15:29
perfect

请问怎么换地址呀

KYT

cuihaofeng 发表于 2024-6-14 14:57
请问怎么换地址呀

解决了嘛？


怎么更换地址啊

zjh2001

KYT 发表于 2024-10-6 19:34
解决了嘛？

请问怎么解决

范小鱼

KYT 发表于 2024-10-6 19:34
解决了嘛？