[ebook] Analog Circuit Design Techniques at 0.5V

duke168 · 发表于 2010-11-18 21:10:21

马上注册，结交更多好友，享用更多功能，让你轻松玩转社区。

您需要登录才可以下载或查看，没有账号？注册

x

本帖最后由 duke168 于 2010-11-18 21:22 编辑

Shouri Chatterjee, K.P. Pun, Nebojsa Stanic, and Yannis Tsividis, "Analog Circuit Design Techniques at 0.5V"
S***r | 2007 | ISBN: 0387699538 | 158 pages | PDF | 3,3 MB

This book tackles challenges for the design of analog integrated circuits that operate from ultra-low power supply voltages (down to 0.5V). Coverage demonstrates the signal processing circuit and circuit biasing approaches through the design of operational transconductance amplifiers (OTAs). These amplifiers are then used to build analog system functions including continuous time filter and a sample and hold amplifier.

From the Back Cover

Analog design at ultra-low supply voltages is an important challenge for the semiconductor research community and industry.

Analog Circuit Design Techniques at 0.5V covers challenges for the design of MOS analog and RF circuits at a 0.5V power supply voltage. All design techniques presented are true low voltage techniques - all nodes in the circuits are within the power supply rails. The circuit implementations of body and gate input fully differential amplifiers are also discussed. These building blocks enable us to build continuous-time filters, track-and-hold circuits, and continuous-time sigma delta modulators.

Current books on low voltage analog design typically cover techniques for supply voltages down to approximately 1V. This book presents novel ideas and results for operation from much lower supply voltages and the techniques presented are basic circuit techniques that are widely applicable beyond the scope of the presented examples.

Analog Circuit Design Techniques at 0.5V is written for analog circuit designers and researchers as well as graduate students studying semiconductors and integrated circuit design.

Analog Circuit Design Techniques at 0.5V_0387699538.rar (3.32 MB, 下载次数: 492 )