急！急！！急！！！最高分求助一个VHDL程序的编写！！

kscc0202121

实现对32组数据的顺次输出及编号（编号依次为01-32，与数据一一对应）的在两个LED显示。

要求：
（1）每组数据输出间隔为2s,32组数据全部输出后，再从第一组输出，如此循环，且编号能在LED显示。
（2）外部输入信号U1如果为0，继续输出；如果为1，编号在LED闪烁显示10s后，继续输出下一组。

已知条件：
（1）32组数据依次为："00000","00001","00010","00011","00100","00101","00110","00111","01000", "01001","01010","01011","01100","01101","01110","01111","10000","10001","10010","10011","10100","10101","10110","10111","11000","11001","11010","11011","11100","11101","11110","11111。
（2）2s和10s的延时我已用计数器实现。时钟为1MHZ,以延时2s为例，每计数2000000次后，输出Delay_2s为1。延 时10s计数器计数10000000后，输出输出Delay_10s为1。

附：
（1）LED端口大侠们可自行定义；
（3）不知道能不能用到WAIT UNTIL语句？？