MECHATRONICS 机械电子

pelijava20

MECHATRONICS 机械电子

Robert H. Bishop
A CRC title, part of the Taylor & Francis imprint, a member of the
Taylor & Francis Group, the academic division of T&F Informa plc.
Boca Raton London New York
University of Texas at Austin

类似于Handbook,附件序号和章节是对应的，可以有选择下载

Contents
1
What is Mechatronics?
Robert H. Bishop and
M. K. Ramasubramanian ...........................................................................
1-
1
2
Mechatronic Design Approach
Rolf Isermann.........................................
2-
1
3
System Interfacing, Instrumentation, and Control Systems
Rick Homkes ..............................................................................................
3-
1
4
Microprocessor-Based Controllers and Microelectronics
Ondrej Novak and Ivan Dolezal .................................................................
4-
1
5
An Introduction to Micro- and Nanotechnology
Michael Goldfarb,
Alvin Strauss, and Eric J. Barth .................................................................
5-
1
6
Modeling Electromechanical Systems
Francis C. Moon...........................
6-
1
7
Modeling and Simulation for MEMS
Carla Purdy..................................
7-
1
8
The Physical Basis of Analogies in Physical System Models
Neville Hogan and Peter C. Breedveld ........................................................
8-
1
9
Introduction to Sensors and Actuators
M. Anjanappa,
K. Datta, and T. Song ................................................................................
9-
1
10
Fundamentals of Time and Frequency
Michael A. Lombardi ................
10-
1
11
Sensor and Actuator Characteristics
Joey Parker ..................................
11-
1
12
The Role of Controls in Mechatronics
Job van Amerongen...................
12-
1

13 The Role of Modeling in Mechatronics Design Jeffrey A. Jalkio ........... 13-1
14 Design Optimization of Mechatronic Systems Tomas Brezina,
Ctirad Kratochvil, and Cestmir Ondrusek................................................. 14-1
15 Introduction to Computers and Logic Systems Kevin Craig and
Fred Stolfi ................................................................................................ 15-1
16 System Interfaces M.J. Tordon and J. Katupitiya ................................... 16-1
17 Communications and Computer Networks Mohammad Ilyas............... 17-1
18 Control with Embedded Computers and Programmable
Logic Controllers Hugh Jack and Andrew Sterian ................................. 18-1
19 Introduction to Data Acquisition Jace Curtis ........................................ 19-1
20 Computer-Based Instr umentation Systems Kris Fuller ......................... 20-1
21 Software Design and Development Margaret H. Hamilton ................... 21-1

pelijava20

不错的自控文档 自己顶一下

baotong

Thanks

jeff17.ren

Thank you for sharing.

jeff17.ren

Thanks again.
Nice book

jeff17.ren

Thanks again.

jeff17.ren

Thank you so much.
I study mechatronics.